---
/
---
SYS/DIA (mmHg)
---
/
---
SYS/DIA (mmHg)
BP+ Connect
Measurement Results
| Measure | Units | Result |
|---|
Run a measurement to see waveform charts.
Set the connection type — a page refresh is required after changing.
Serial API available: checking…
Bluetooth API available: checking…
-
Connection
-
Flow Control
-
Serial Tracing
Flow Control: applies to the uConnect S2B5232I adapter only (sets config byte 3: 0x02=RTS/CTS, 0x00=none).
For Hardware to work the BP+ device must also have flow control enabled
(Menu → Setup → Hardware). Recommended on Android to prevent XML data loss.
The NUS Bridge and other adapters manage flow control in firmware — this setting has no effect on them.
Serial Tracing logs every TX/RX byte below (blue=TX, green=RX, brown=CFG).
CFG trace shows actual config bytes sent — verify byte 3 is 0x02 (HW FC) or 0x00 (none).
A page refresh is required after changing Connection or Flow Control.
Version …
Debug / Trace
Debug output appears here